The Lattice Semiconductor Byte-to-Pixel Converter IP converts CSI-2/DSI standard based video payload packets from D-PHY Receiver Module output to pixel format. In addition, Byte-to-Pixel Converter IP generates camera/video control signals in the pixel domain, based on CSI-2 or DSI synchronization packets.
LIFCL-40, LIFCL-17, LFD2NX-40, LFD2NX-17, LIFCL-33, LFCPNX-50, LFCPNX-100, LFMXO5-25, LFMXO5-55T, LFMXO5-100T, LAV-AT-E30, LAV-AT-E70B, LAV-AT-E70, LAV-AT-G70, LAV-AT-X70, LAV-AT-E70ES1, LAV-AT-G70ES, LAV-AT-X70ES
| 1.7.0 |
Quality enhancement. Other bug fixes. Minor GUI enhancements. |
| 1.6.1 |
Fixed timing issue encountered in DSI configurations. Fixed output issue encountered when AXI4-Stream Transmitter Interface is enabled. Updated constraint file. Added support for 4 output pixel lanes for RAW12 data type. Other bug fixes. Minor GUI enhancements. |
| 1.6.0 |
Added Lattice Avant support. Separated the rtl per data type under CSI-2 configuration. Updated constraint file. |
| 1.5.0 |
Added MachXO5-NX support. |
| 1.4.0 |
Added DSI Sync Packet Delay attribute. Fix for unintended early read from the FIFO even when the GUI threshold is manually adjusted. |
| 1.3.0 |
Fixed lp_av_en issue encountered in DSI configurations. Fixed synthesis issue encountered in Synplify Pro. Updated constraint file. |
| 1.2.0 |
Added CertusPro-NX support. |
| 1.1.1 |
Added support for RAW12, RAW14 and RAW16 data types. Fixed wire declaration of ports (multicycle nets). |
| 1.1.0 |
Updated RTL to optimize FIFO instance. Added RX and TX data rates(read only). Updated IP to work correctly for YUV420_8 and YUV420_10 data types. Removed Odd/Even attribute from YUV data types. Fixed threshold calculation issue for small word counts. |
| 1.0.3 |
Added Certus-NX support. |
| 1.0.2 |
Updated for Radiant 2.0 Service Pack 1. |
| 1.0.1 |
Production release. |
| 1.0.0 |
Initial release. |